Looking to organize your tools and keep your workspace flexible? A mobile freestanding pegboard might be just what you need. In this tutorial, I’ll show you how to build one that rolls anywhere in your shop and keeps your gear easily accessible. Whether you’re a seasoned maker or just getting started, this project is simple, practical, and totally customizable.
What You’ll Need
Here’s a quick list of the tools and materials for this build. I’ve also linked a downloadable PDF diagram at the end of this article for your reference.
Materials:
-
2x4 lumber
-
Pegboard panels
-
Casters (4¼” tall)
-
Screws (#10, 2¼” wood screws)
-
¼” x 2” machine screws, washers, and nuts
Tools:
-
Chop saw or circular saw
-
Drill/driver
-
Measuring tape
-
Square
-
Wrench set
Dimensions & Design
We’re framing this out like a traditional wall, but with mobility in mind.
-
Width: 48 inches
-
Height (pegboard only): 32 inches
-
Total Height (including feet): 71 inches
-
Clearance below for tool chest: 39 inches
-
Foot Length: 36 inches (for extra stability)
-
Brace Piece: 15 inches long side x 12 inches at base and leg
Note: Even though 2x4s are labeled as such, they’re actually 1.5” x 3.5”. Keep that in mind when measuring!
Download the Materials List and Diagram for the Mobile Peg Board for FREE
Step-by-Step Build
1. Frame the Pegboard
Lay out your 2x4s and space the vertical studs 16” on center. This ensures your pegboard panels will line up perfectly. Secure everything using your 2¼” screws.
2. Attach the Feet
The feet are also made from 2x4s and measure 36” in length. Attach them to the bottom of the frame for stability. Since we’re using this to hold heavier tools, we’re going with a wider base than average.
3. Install Casters
Each caster will sit about ½” from the edge of the foot. Mark your drill holes, then pre-drill and attach the casters using machine screws, washers, and nuts. These will give your pegboard smooth mobility.
4. Brace for Strength
Cut a 15”x12” triangle or angled piece to brace each side of the pegboard where it meets the feet. Screw into both the foot and the vertical beam. This adds crucial lateral stability, especially if you’re storing heavier gear.
5. Attach Pegboard Panels
Flip the unit over, line up the pegboard panels, and screw them into the studs. Make sure everything is level before final attachment.
Final Setup
Once the panels are attached, it’s time for the fun part: loading up your pegboard! Add shelving, hooks, bins, and get your tools dialed in for your workflow. Bonus: we designed it so your rolling tool chest can slide neatly underneath.
Download the Plans
Want a printable diagram with all the dimensions and assembly notes? [Download the PDF here].
Wrap-Up
This mobile freestanding pegboard is the perfect addition to any maker’s workshop. It gives you flexibility, storage, and a cleaner space to focus on your builds.